Washing Machine Bearing Replacement

Washing machine bearings help the drum spin smoothly. If your washing machine is making a lot of noise, the bearings might need to be replaced.

Signs You Need to Replace the Bearings

• Loud noise when the machine is spinning
• Drum moves up and down more than usual
• Water leaks from the bottom

Tools You Need

• Screwdriver
• Wrench
• Hammer
• Bearing puller
• New bearings

Steps to Replace the Bearings

1. Unplug the Washing Machine

Safety is important. Always unplug the machine before starting.

2. Remove the Back Panel

Use a screwdriver to remove the screws from the back panel. Take off the panel to see the drum.

3. Take Out the Drum

Use a wrench to remove the bolts holding the drum. Carefully pull out the drum.

4. Remove the Old Bearings

Use a bearing puller to take out the old bearings. You might need a hammer to tap them out.

5. Install the New Bearings

Place the new bearings in the drum. Use a hammer gently to tap them into place.

6. Reassemble the Washing Machine

Put the drum back in place and secure it with the bolts. Reattach the back panel with the screws.

7. Test the Machine

Plug in the washing machine and run a short cycle to check if the noise is gone.

Tips

• Always buy the right bearings for your washing machine model.
• Take your time and be patient.
• If you are not sure, ask a professional for help.

Replacing the bearings can save you money and extend the life of your washing machine

---